开云体育

I agree with Mark. There seems to be some confusion about the original and primary benefit of the Fritz & Franz - that being the ability to pinch or trap-squeeze small parts between the Fritz and the

I’ll sell my Felder fence. I only use the table part since I got Brian’s. Not sure what for a price though. Bill Belanger

How is that used to cut small pieces, like cross-cutting a 1”x1”x 2” long piece (i have cut them smaller than that - Not seeing it, David Bedrosian ff or ones like it are perfect for that.

Wow Derek, is that NASA issued model? ? Wade

Like many others, I made and used a F&F jig soon after sliding down the slider hole with my K3. Over time, I found that I much preferred the precision and versatility of a parallel fence ...

For those of you that are not on Instagram, you can watch a YouTube video showing my jig done by Ramon Valdez -- https://youtu.be/z2fg6Ex9VEI While you are on Ramon's page, you should check out some

Thanks for the interest in my Fritz and Franz jig.? If you are on Instagram, you can see all of my related posts on the jig by searching for the tag #BedrosianFritzandFranz.? You can DM me on

I think I already have the extension table (430-104) for the Felder parallel fence. If someone wants to sell their fence (because it doesn't fit, or they bought Mr. Lamb's) let me know.

I have seen them in a shop here in Auckland, the owner was closing his shop, the asking price was a bit high but it did cost him some serious $$ to buy, it was sold within a week.

That’s a really nice setup! In my Case it might soon become a junk collector though. ? Bill B

I don’t know if this helps but my fence on the end is about the same gap as yours. I raised the fence rail just a little bit and the back of the fence is about 1/8” higher then the table. I have

This was my first F&F attempt. I left out the rail as I wanted flexibility for angled cuts. I also introduced Kipp levers to fasten the clamps down, after applying some forward pressure on the

Same here. I bought the Bedrosian FF for my K3 then modified (new slot) it for my KF700. It is a very well made kit with solid flip stops. Made a holster for it modeled after what I saw on Mark

This is the most basic of all F&F jigs. Cost is almost nothing. This will help me make a better/fancier version. If you want a Bedrosian version, you can reach him through Instagram. -- John Hinman

Well I got weak in the knees and bid on a lot of router bits. Only got duplication of these 2, made in USA PC cove bits. I see comparable bits would be ~$100. Offering for $50 plus shipping. Cat not

I built a pantograph a few years ago om birch ply for a router to carve letters and such.? It was terribly? easy. You could just watch? Mathias' videos and? get all the detail you need.? The

Being a nut with calipers as DB puts it, I know the feeling super well when the machine I dreamed about did not turn out to be perfect. For me $7K back in 2001 for a bare bones KF700 was a ton of

I spoke with a tech yesterday. While being very nice etc, he suggested maybe putting some washers under the 6 screws to raise it up. I was hoping for something better than a? "make do" approach. It

Could one of you post a picture of your jig plus the contact information please? How much does it cost? Thanks, Ed Cohen E. Cohen Designs [email protected]> wrote:

David, That review was fantastic. You should consider making more video reviews of whatever you fancy. Bonus: you taught us how you make your Caesar salad dressing. Thanks. Warm regards, Lucky