I don¡¯t know if this helps but my fence on the end is about the same gap as yours. I raised the fence rail just a little bit and the back of the fence is about 1/8¡± higher then the table. I have used the planer and jointer a lot with no problems. I thought when I put it together it had a bigger gap then should be. But like I said no issues the wood comes out as square and as flat as I would ask for. ?Sorry if no help.?
On Thursday, March 10, 2022, 08:03:34 AM CST, williamjoecowan@... <williamjoecowan@...> wrote:
I spoke with a tech yesterday. While being very nice etc, he suggested maybe putting some washers under the 6 screws to raise it up. I was hoping for something better than a? "make do" approach. It seems the fence is tilted from front to back and should not be that way. I will figure it out on my own. Once I install the extension table, I will see if I can raise the bracket to help the cause, however I am sure the bracket is installed exactly to the specs given to me in the manual.
