开云体育

Thanks for sharing this, However I still don’t see what the tolerance is from the outfeed table to the cutter head. Thanks, JT

?This was shared here some time ago Imran

This was shared here some time ago Imran

Can someone tell me where to find the specs for the A3-31. My infeed/outfeed are no longer co-planer. I am trying to setup the outfeed table and would like to know the distance to the cutter head. I

Ariel, I have even heard of blank ICs with no silicon whatsoever, LOL I retired end of 2019 and prior to that our company split into Aptiv and Delphi Technologies (which was later acquired by Borg

Imran, you are right about potential counterfeit of electronic components, it has a history that goes back to the 80's with memory chips being "remarked" and later on with more silicon products either

I should think? that some enterprising? person? would long ago have? started churning out 3-d printer versions of these things. My Hammer? ZCI iused to be a real PITA? to make but I figured out

Hi Paul, My pet hate too!? The gap in between the tables, always seems you want to mount the fence right in it!They used to make a fence extension that could be used here it was part no EZ A(14/14)?

Martin, I had forgotten about the old cast iron clamp on extension, I'm pretty sure that the cast extension in the drawing bolted to the planner table on the 6-41, and was only available in the F

I should think that all that other stuff must become fastened securely? to the saw thus adding to its mass.?? It's either that or the saw will rattle around? inside the confines of the external

The S Coupling has always been a bit of a challenge to set up and maintain, I have looked at bolting F rails onto the dovetail to convert the whole machine up to the F Coupling but you end up with a

@This is a great point. It has been a few years since I've used a traditional table saw..... that blade is going to feel very close!” ditto on working without clamps on slider. I did not realize how

Jason, missed the LED light question. Is an option on the k940 and up, indicates that the scoring is on and up. I really like it, because use aolid wood for the most part i use the scoring either

Jason, Curious if your KF has scoring. I bought ZCI from John R for my KF sans scoring and never installed it. K975 is a diff story. I don’t care much if the off cuts go down in DC. However, more

Annu, I don't know what a c31 is but you might try straightening it.? Some materials like hot rolled steel keep a memory of their original shape.? Heat, quench and some persuasion can relieve the

I measured the space between the blade teeth and the table on my Kappa 400 and found it to be 3.2mm What is the gap on the K940? Bill Bélanger

I am also interested to know more about the reason for a ZCI. I have small off cuts sucked inside the saw chassis or the scoring blade is throwing the small off cuts toward the main blade or downward

JP, Not sure if the same design would fit, would have to confirm when you get it. Anthony, I started it in Siemens NX but the version I am using is customized for mold making and I don’t use it

Use extension roller? with Erica for ripping? ?the Facia on my shack is clear V fir 1.5 x 11" all corners required compound miters. with erica just lay 18' plank on table clamp , support the end

Hi Paul,Never liked the S coupling to hard to set extension tables and maintain accuracy. I would change to FA few things i did way back when that were helpful?Motorized planer table, used a 120 volt