Re: Job site saw recommendation?
|
Use extension roller? with Erica for ripping? ?the Facia on my shack is clear V fir 1.5 x 11" all corners required compound miters. with erica just lay 18' plank on table clamp , support the end with roller and pull saw through for perfect cut.?
On Thursday, January 21, 2021, 09:14:14 AM CST, mark thomas <murkyd@...> wrote:
On Thu, Jan 21, 2021 at 06:47 AM, Jason Holtz wrote:
Ripping a 12' 2x6 on a jobsite saw that weighs less than the board you're cutting is a challenge as well. You couldn't do it solo anyway.
?
It's a piece of cake.? You push it half way through to the balance point, then walk around to the other side, and pull it the rest of the way.? With heavy boards, you need to screw the saw down to something with a little heft, or clamp it to your tailgate, etc.
|
