开云体育

Thanks Joe. Luckily David Best suggested that I keep the stock fence plates when I upgraded, so I still have them. Since I have a router table, I'm wondering if all the switching time is really worth

I bought the on/off switches for K975 on ebay which basically is a mechanical part. For readily available electrical component like the start cap, that I only need one of in a decade I prefer reliable

Since you will give the saw to your dad eventually, then buy the best job site saw, that is a great way to say Thank You. https://www.timberwolftools.com/mafell-erika-85ec-pull-push-saw James wrote:

As mentioned previously, we are about to start the new workshop.? Looking for a stop-gap saw to help with the construction and until I move into the bigger space where I will get another slider.?

Hi Guys, The saw sold yesterday to a really nice guy down on the Cape. ?Excited to have the great saw in a new shop where it will get lots of use. Thanks to all those that helped facilitate this

I find eBay to be a great source for these items with competitive prices and included shipping. Take a look: 50UF 450VAC Motor Run Capacitor 450V AC CBB60 50 UF Round White 50/60HZ Cap (

I think WWTW sells parts too. There might be some prices on the website for comparison. Dave ________________________________ Sent: Wednesday, January 20, 2021 11:50 AM To: [email protected]

I decided to try the guides that came with the saw, the Tannewitz on the upper and the Carter on the lower. I have ordered new wear blocks for the two guides and I have new rear bearings for both.

Bill, if you don’t modify the hood as other described you need to use the Felder plates. I ordered my machine with the Aigner option and they shipped with the Felder plates too. Sent: Wednesday,

Mark, Sorry that you weren't able to purchase a ZCI, but selfishly I'm very much enjoying watching you work though this design. ?Very impressive!

Jack, John Renzetti used to make them. I can sell one for sure maybe both since my KF is a shaper only machine now. I will need to locate them first, LOL Imran

Yes more complicated with auto scoring. For my saw however, scoring is an intentional act it is easy to implement the LED with just the scoring motor control switch. Imran

Where did you get the zci for the KF700?

Hi Greg, Thanks for the details. I do not know the internal design of selector switch so thought may be the old knob is slipping around TDC and the contacts are mid movement position therefore nothing

Thanks Brian, 3d printing saves so much rework time for this kind of stuff for sure! Regards, Mark https://www.instagram.com/kessler_woodworks/

Yes is simple to add the LED however they are sensing when the blade goes on (obviously) but also in the case of auto scoring when the scoring is fully retracted plus a few seconds, the LEDs don’t

https://machinerymax.com/Event/LotDetails/25800381/Altendorf-C45-Sliding-Table-Saw

Mark, I do not mean to bad mouth but somehow LED feature is less impressive when seen gutted out. Your post is very timely. I am working on adding wireless switches to my slider. It did not occur to

Hi Imran, I power off the main switch, then move the selector dial to the machines that do start, and then power back on. So long as the selector remains on either J/P (or horizontal mortiser) or

Mark, That is so cool, thanks for sharing. BTW, does your K940 maintain rip fence measurement when blade is tilted? My KF does but it was a surprised to learn that it did not on K975 - only found out