开云体育

Chicago School of Woodworking 5680 N. Northwest Hwy Chicago, IL 60646

I did some 45 degree cut in plywood and apparently, the scoring blade is not working at this angle. The collar that is used to screw the scoring blade to the arbor protrude from the scoring blade

It would help to know the machine and vintage that the spindles fit on… Mike

I would guess Chicago from the email address...

Where are you located?? I might be interested in the AD741. Brian

If available, I would like 04.0.071 Boxed 13-pair Universal Safety Cutter Head Regards, Chris Perren 512-415-6951 Sent: Sunday, October 18, 2020 12:51 PM To: [email protected] Subject: [FOG]

I would love the two rebate cutters 04.0.182 if they are still available.

oops – I didn’t realize Imran already requested it.. I’m happy to be the backup. Regards, Chris Perren 512-415-6951 Sent: Sunday, October 18, 2020 2:38 PM To: [email protected]

I’m interest in the FELDER? Tenoning plate.. Regards, Chris Perren 512-415-6951 Sent: Sunday, October 18, 2020 12:51 PM To: [email protected] Subject: [FOG] #forsale I am selling Felder

Also interested in the groovers, but I assume they are 30mm bore? I need 1.25” [email protected]> wrote:

i would take the tenoning plate if available. imran

I’m interested in one of the adjustable groovers.?Shawn(707) 499-9347

What is the bore on the Zuani cutters? Dave Davies

I am selling Felder shaper spindles, shaper tooling (most new or like new condition), a horizontal mortiser and a 2005? AD741. This is the link to the list.

Marlow everything you want in a facer. My EMA is the same but no tersa ,,,darn darn darn. Mac,,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell

You can polish your shaft with a marron pad while it spins and you can wipe on LPS 1 and wipe it off . No grease! martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106

There is always a way I’ve been doing this a long time so have presses, pullers , bearing, heaters, torches couple cranes , needle scalers and on and on. But like I said always a way ,,, bearing

Well I'm glad that you're not totally defeated yet! My Oliver 192 has yet to cut a board and I've had it almost a year ? Sounds like you've got good machinist help too, as do I. I did pull the

If the bottom isn't flat ( except for the ears ) that is a sharpening issue. After boring, the teeth should be tipped off by the sharpening service to ensure the bottom is flat. FS Tool are good

FWIW, I use FS Tool 6-inch dado on my K3, re-bored for Felder.? It cuts bat ears with somewhat flat bottoms.? Maximum dado depth is 5/8 inches, a height that is limiting occasionally.? I don't