开云体育

martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com instagram.com/maccampshure/ Designing and building for

I put a few slots in the guard and couple screws, so I can remove when in the way, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

Bill, I’m curious what the pin set-up looks like. I don’t have a pin, just a bolt that goes into the arm to hold it in place. Someday when you are in your shop, would you please share a picture

I don’t have a picture for you because I’m on vacation, but I used a throttle cable setup for a lawnmower to pull and reset the pin. Bill Belanger

Moving the overarm guard/dust hood out of the way requires walking around the saw and unscrewing a bolt. This is a nuisance if all that is needed is to get the guard out of the way to check a

Thinking a little further south? Tolve construction

Joshua Tolve ( # ) Come to the dark side of California :)

David, the metric scale on the rip fence only costs $27, ?so it isn’t that expensive. I can also go with Oregon scales, but for me it looks like a modification that should be free considering this

Showroom? What is this mythical creature you speak of? Tolve construction

I agree - the difference was much less a few years ago - like $3,500. Yes, the 240 shaper hood is heavy, but it’s easy to tilt it forward onto a towel laid on the sliding table, and then off onto a

Mac, I’ve learned so much about these machines since buying this first one and if I do it again things would be ordered differently for sure. And it wouldn’t be a Felder! Your clamps have been

Wade you must be bummed, This is a machine design that is done day in and day out with very few issues the more functions built in the more can go wrong. I have motorized spindles on different

On Fri, Jan 19, 2024 at 02:05 PM, Wade Dees wrote: > > > Hi Andy, > > I’m dead in the water. ?No manual or override available. > > I’ve just had the worst luck with their service. ?This is

Hi Andy, I’m dead in the water. No manual or override available. I’ve just had the worst luck with their service. This is my third issue with the machine and each time dealing with Felder Tech

All these issues with the power drive feature. On these higher end saws is there an alternate way to raise and lower the blade (ie handwheel)? Or are they dead in the water when the power drive goes

Hi James, Hey I’ve never been over to Austria, but maybe, with their twisted mind set, all of the car dealer lots have their cars up on blocks. ? * Another side note regarding absolutely horrible

Mercedes used to import the rigs with no oil I was told. I drive old ford 150’s martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

It is absurd and ridiculous that a 10K+ saw does not come with a brand new blade. Who would buy a car without tires? James

You can zero to Blade 0ff slider /table than raise to desired depth , Very acurate . Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

I have actually made cuts using a normal blade where I need an exact blade height: https://www.youtube.com/watch?v=d8VIp-p4yCY -Aaron