开云体育

I agree that for the J/P it is way more convenient to have the K1/K2 motor and not spin it my hand. I have the digital spin the A3 and it is easy to adjust to 0.1mm with it (and probably dado will be

Installation/Commissioning on a K700S is $1,395, they also like you to buy a new blade and scorer at the same time, so its there for setup. Regards K1 / K2, I've personally got it on my AD941, and I

Yes, I saw that but like you, not sure how it actually works. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Todays powerdrive K1 looks like this, so it’s hard to tell how it operates from the photo. Perhaps it’s a dual function button for fast and slow adjustments.

It's been a while... Profil 45 now working again. Tech came again last week.? He was great.? Patient and thorough.? He finally found a contactor that had a burnt out actuator coil. What was

My suggested commissioning tool list can be found on my website: https://davidpbest.com/publications-and-videos#felder David

For the phase convertor, I'll call tomorrow to Phase Perfect to see if the 7.5HP unit will be enough (I see that the output of American Rotary 10HP and PP 7.5HP are almost identical) We haven't

That configuration sounds like a winner. If the shaper add-on adds that much to the price of the machine, you’d be better off getting a stand alone shaper later. Ask Brian to quote you on a DRO

Ask him for the form I got from Wurth for a reduced sales tax rate in CA for machinery... I am amazed that Felder does not offer it... PK

So apprrently the 3-phase (5.5kW) saw together with a longer bed (3.2m vs 2.8m) and the overhead dust costs less than buying the single phase saw and adding the overhead dust port. I think I'll go to

Just FYI, the capacitors are easy to replace and will set you back about $100 every 5 to 10 years if you don’t have the bank (money or available power, lol) to add a phase converter.

That’s terrible! If I lived where that was a possibility, I would have this on my water

That’s shocking bad. I think about getting a leak in the roof or something, but nothing like what you just described. I feel for you! Warm regards, Lucky Dr David Luckensmeyer From:

A water line burst and the water flood brought down about 20 percent of the ceiling of my and may have been 2 inches deep before I could turn off the water, based on the stains on the walls. The shop

Thanks David. I figured you and Dan jumped later in the conversation and missed the fact that I don’t have powerdrive on K975. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Imran, here is a photo of the control panel on my K975 FYI: ? David Best DBestWorkshop@... https://www.flickr.com/photos/davidpbest/collections/ https://www.youtube.com/@David_Best

Hi Dan, You may not have read earlier msgs. The discussion is about only having the electronic height control and NOT having full powerdrive. I mentioned earlier, that this is implemented on my saw

I probably won't have enough amp in my breaker box for a huge Phase Perfect. I alreay have a 60A circuit for a car charger. 50A for a range 30A for the AC 30A for electric dryer And the shop

Aaron, Not sure how to take the deep pockets comment *;-)* but this is my only hobby and soon it will, fingers crossed,? drive some income for us too.? We bought the home new and have been here for

As far as I know, powerdrive K2 refers to height and angle control, K1 would be for height only. Here’s a short video showing the operation. The spring loaded switch gets you close to where you want