开云体育

Okay, thanks everyone. I'll just leave this adjustment alone. I spent virtually the whole weekend getting the infeed table coplanar with the outfeed table and got every measurement point within

Yes. It’s similar in scope, but I don’t recommend it for something like 0.005” difference across the thicknessed material. The adjustment is accomplished by altering the planer table height on

Andy, I’d say that’s close enough for the girls I go out with! ???? Wade

Dan, The Felder Fat 300 S is on sale right now! Save $95 ???? Wade

Tom Morris, Which model Barth? Would you mind sharing the cost? Thx, Wade

Nothing wrong with the Husky carts, I have three 54” benches and I use them as material carts around my shop. They double as infeed/outfeed for jointer, planer, and wide belt sander. For $220 a

/g/felderownersgroup/topic/felder_fat_300_table/36446730?p=Created%2C%2C%2C20%2C1%2C20%2C0&jump=1 /g/felderownersgroup/topic/76914906#109792

I bet it's more likely an errant chip stuck somewhere or inconsistent wood density across the face will cause your stock to feed slightly off-plane. Or, just run it through twice and/or flip

I have both the Rangate and Barth lift tables, both very nice and equal build quality. I do notice that the Barth raises more per pump stroke. Also, unless they now offer a top option, the Rangate

LArry Long Neck - 10mm allen bit on a drill solves the problem. wrote:

I bought the 6ft long adjustable husky rolling bench and put a 4'x8' torsion box table on top of it instead of the top it came with. I use it as my main assembly table. Only problem is that the hand

I'm also done with the self-commissioning of my new AD941. I ran a couple of 3" wide pieces of red oak, one on the left side of the planer ("thicknesser") and one on the right. There was about 0.005"

Thanks Brett. Good to hear a positive review from someone who owns a couple. Joel, do you have a link for the Husky cart? Is it a scissor lift? I’m thinking of building a larger heavier bench in the

Wouldn’t even consider anything from Husky, but that Barth 300XL & Felder Fat 300S look really nice, especially because these two offer the height adjustment from both sides of the cart. Does anyone

If it is in the stop string, you should be able to go into your electrical panel and find the two connections and check for continuity between those two terminals or even disconnect the wires and use

I have a 500v (not used as a mobile cart) and I have seen other lift carts. ?I was thinking about the Rangate lift cart as my mobile cart after a shop revision, and it was suggested I get a Husky

So, I went to start my CF741 today and no luck. Power is on to the machine, the reverse light does not illuminate, so I presume it is a failed stop switch. I’ve blown out the ones that I’m aware

Not sure how it compares to Barth/Felder, but I have 2 Rangate lift carts in service since beginning of 2023 and 1) they are worth the price and 2)they are underrated in performance specs. The casters

I’ve been doing more rough carpentry jobs in my garage and was thinking a rolling cart would come in handy. I currently have the Barth 300 and 500v in my basement shop and wouldn’t be without

Just got this after the discussion this morning on indicators and bases. I have no idea if this “sale” makes them better than you can find elsewhere, but it is worth looking, note they are free