开云体育

I would also list on this site as well as sawmill creek. In addition to Craigslist, I would also list on Facebook market place. Since Facebook market place started, Craigslist has kind of fizzled out.

If you post a list you might find you might find folks here that want to purchase the smaller stuff stuff as well. -- Michael Garrison Stuber

I would be interested in lots of add-ons for the saw/shaper. let me know if you are selling those separately. Thanks Eduardo

Hey Bill, How much do you want for the hammer a3-41? I am in N. California and might be interested. Is it straight blade or silent power? Any photos would be great! Thanks! Peter

Post the details here, always new people looking to find a nice used machine. Location, pictures, will you help crate for shipping, all that sort of information. Brian Lamb blamb11@...

Hi Everyone! Greetings from sunny California! Will be retiring in the next few months and moving to Europe. Therefore, I need to sell all of my woodworking equipment and could use some advice. For my

Yep, familiar with them. I was just curious if Mike had that on his model slider as well. Thx, Wade

Wade, you should see two black arrows pointing down on the side of your slider indicating locking positions.

Mike, Does your slider at least lock in the far pulled back position? What is the red band for under the black horse shoe handle? Thx, Wade

Just out of curiosity, regarding the slider lock, could you not swing one clamp arm over so that the clamp could press down on the cast iron table? Thinking that might provide enough stability to load

Not, if you use the shirt xcut fence and would like to leave that nut installed. I have changed handles on my clamp to cam type so now I just unscrew it - much faster than the original kip lever. I

Can’t the long tee nut slide in with the other install locations? Regards, Mark https://www.instagram.com/kessler_woodworks/

Mike, That lower handle is nice. I had to cut a slot in mine. Imran

K940s Lowered the handle and fit both connections on the right side. Added benefit, long t nuts can now slide directly in the end over the handle. These clamps are a must have for anyone impatient.

Brian is right, remove the other cover as well. It’s been awhile since i did it… Regards, Mark https://www.instagram.com/kessler_woodworks/

“ Steve Lyde 8:11am #122207 ( /g/felderownersgroup/message/122207 ) I have that same guard ordered for my K700S. It’s nice to have little nuggets like this tucked away just in

Those posts are eccentric. I assume you have to loosen the side opposite what we see in the picture and rotate the posts will change the placement of the bearings. Brian Lamb blamb11@...

It seems my guard is slightly different. There are three roller bearings and a spring that applies pressure to the plastic bearing guides. The ends of the posts have eccentric threaded holes, but it

I just recalibrated my last night using a machinist setup block. My mfd sub fence ends are cut off by the blade and using the setup block flush to the end on both Fritz and Franz I move the stops,

My switch configuration is different and did not lend itself to the treatments I've seen before. So here is what I came up with, which worked out very well and didn't require anything other than