开云体育

Jerry - you can do exactly that with my Fritz and Franz jig.? You can set the stop on the front scale to the desired location and then slide up the back portion and set its stop exactly the same as

Glad I was able to help. I’m not surprised that it’s the same extrusion, wouldn’t make sense for felder to make/sell a different extrusion for that parallel fence attachment vs the shorter table

Dan, I did not expect it but my extrusion is same behind the cover plate. Would need to tap the AL for for kip levers. My table is 19 3/4” so the range will be limited but enough for me. Imran

Wade those are 13.4 mm on the bottom, 8.6mm on the top, 6mm deep groove under the lip, and 9mm deep overall

? The way my shop is currently laid out, I’m only able to get about 10” of cut capacity on the parallel fence before the planer gets in the way. That’s the downside of using the parallel fence

The way my shop is currently laid out, I’m only able to get about 10” of cut capacity on the parallel fence before the planer gets in the way. That’s the downside of using the parallel fence

Dan, I’m curious, what size are those t-slots in the support table? Thx, Wade

Here’s how the measuring part attaches to the support. It seems like you’ll probably just need to purchase some kipp levers and you should be able to make it work. How long is your support table

I hear yah Dan, its too bad Felder doesn’t offer that longer support table as a separate item anymore, or else I could use Bill’s scale rod. I’m going to order Lambs fence, most likely the

Bill, Thanks for the length and pics. To people who are familiar with Felder parallel fence, could I attach the bracket of the rod with scale (from the parallel fence) to the end plate of this

I do the same as Bill, the measuring devise lives on a shelf most of the time so far.

Ah, okay. Thanks Bill

Just the rod/measuring device. I use the platform to support plywood. Bill Bélanger

Bill, Can’t remember if this was a completely parallel fence or just the stop rod? Thx, Wade

Message sent! -- John Hinman Boise ID K700S, and expecting an A941 in April 2022

To the guys that expressed interest in ordering an insert (Ed, Mike, Jared, Wade, John), they are done! I routed a slot in each piece for the riving knife. One thing to keep in mind when installing

1290 long

Hi Bill, How long the the extrusion with scale and can you share a pic of the bracket by the reticle? I would like to figure out how I can attach it to an ext table and use it. Imran

Mike has decided his base is too short for the readout so if anyone else needs it make me an offer. Bill Belanger

That’s how I do it also. Mark Foster