On Mar 12, 2022, at 9:32 PM, imranindiana <imranindiana@...> wrote:

?

Dan,

I did not expect it but my extrusion is same behind the cover plate. Would need to tap the AL for for kip levers. My table is 19 3/4” so the range will be limited but enough for me.

Imran

On Mar 12, 2022, at 9:19 PM, Dan Gavrilyuk <dgwoodco@...> wrote:

?

Here’s how the measuring part attaches to the support. It seems like you’ll probably just need to purchase some kipp levers and you should be able to make it work. How long is your support table attachment? The standard one on the parallel fence is 31.5” long. If yours is shorter then you’ll have to trim the measurement part most likely.?

On Mar 12, 2022, at 9:02 PM, imranindiana <imranindiana@...> wrote:

?

Bill, Thanks for the length and pics.

To people who are familiar with Felder parallel fence, could?I attach the bracket of the rod with scale (from the parallel fence) to the end plate of this extension table that I have for use as a parallel fence? not sure if it is secured properly as it is attached with a single bolt at bottom.

The end of the this extension is almost 33” from blade so I understand that I will not be able to use the full range.

BTW, what are the cases where one would need the 50” range. I cannot imagine parallel ripping more than 12” wide regularly. So if you have a 36”+ wide piece and would like to rip into three 12” wide boards, would you not prefer to set the parallel fence once to 12”, clamp the piece and rip a 12” board and repeat.

Imran?

On Mar 12, 2022, at 5:01 PM, Bill Belanger <Bill@...> wrote:

?

1290 long

On Sat, Mar 12, 2022 at 13:12 imranindiana <imranindiana@...> wrote:

Hi Bill,

How long the the extrusion with scale and can you share a pic of the bracket by the reticle? I would like to figure out how I can attach it to an ext table and use it.

Imran?

On Mar 12, 2022, at 1:08 PM, Bill Belanger <Bill@...> wrote:

?Mike has decided his base is too short for the readout so if anyone else needs it make me an offer.

Bill Belanger