开云体育

Hi Murray, ? Typically run cap is much smaller value. Are they both 80uF in the parts list? Either way, the caps should have capacitance and voltage listed on them. Good that you found it could be

Hi Annu I still remain unconvinced that your planer motor is faulty. You have two faulty brake boards. I had exactly the same problem with my machine (although it’s 3 phase and not single like

Thanks Brett. It's nice with first hand experiences like yours to confirm whats doable and whats not IRL :-) Yeah, its still a big consideration how to best move it from the pallet on to the

Ameer, Previous posts have correctly identified the parts, With regards o the length stop the heads of the bolts are intended to go in the slots of the 1100mm extension table with the leg the 1st

Murray, The gob of grey goo is from the failed cap. Joe

Hi Lucky, First I want to thank you for the help with my dust collector way back, and yes I still have a couple of issues with that. my issues are so minor I haven't dealt with them. I know that some

I have one of those plates too and thought it might be a tenoning plate, but I couldn't find any references to it and I couldn't figure out how to mount it to the sliding table. Ironically I just made

Here's my laser solution. This laser's gyro function made it unreliable for install work, but that doesn't matter in this situation. I'm kind of amazed it works as well as it does. [image:

Thanks Imran, I have located the capacitors in the main electrical compartment, they don’t show any obvious signs of damage but from what I’ve read they can simply fail over time so I still

Wouldn’t happen to be not square and plumb digital flip stops would it? Regards, Mark https://www.instagram.com/kessler_woodworks/?hl=en

Hi Glen: I’d be interested to know what are your “minor issues” with the saw? Warm regards, Lucky

I went through a similar process with my saw, going from cabinet saws to slider, K3 to KF700SP.? I am modifying the K3 to make it into a dedicated joinery and dado saw.? If there is an additional

I have the Kappa 400 X motion and love it. I went all digital and at first reluctant but very happy now. I have a couple of minor issues but nothing bad, just haven’t gotten around to getting them

After over 22 yrs. in my hobby shop I am changing things up having ordered my fourth and hopefully last saw. I started out in this shop with a Jet cabinet saw, then after 18 yrs decided to upgrade to

Hi Murray, Ok, with single phase you have the caps Annu mentioned. I am not aware of anything that would not run the motor at full speed other than low voltage. A less than ideal electrical

Ameer, The metal thing is tenon plate. The other things are stops that mount in the grooves of extension tables. They can be used for doing stopped grooves on the shaper or used as length stops.

That plate is the old style tenoning plate. I gave mine to joe Calhoon but wish I still had it. Dave ________________________________ Sent: Thursday, January 14, 2021 5:37 PM To:

Imran its single phase 240 volt

Honestly I've only run 1 board through this machine so far, and it was about 16" long x 4" wide. It was just a test to see if everything was working the way it should...? I'll report back later once

I have no idea what these parts are, or if they even go with the equipment I have. Quick background: got an early 2000's KF700 and AD 741 from a family friend's late husband. She had no clue what