开云体育

10% is not on machines, unless you are referring to Xmas special pricing of machines. Sent: Thursday, December 10, 2020 9:25 AM To: [email protected] Subject: Re: [FOG] VIP Program from

Damn. I just put in for an hs950.

Imran, Your doors look really nice. That's one of my favorite colors too.? There's so many ways to make doors, whatever works.

well, the pros and cons are obvious, fast, easy and pricey :) It really depends on what you do. If you frequently need to make the non-thru cut at different height and angle, then it is worth it.

Can anyone share the pros and cons of?electrical height adjustment and angle adjustment of the sawblade on the KF700 (or other Felder slider saw). I am planning a purchase. Slider will be 9 feet.

like Brian said all is in his email. he also had a pic of one side of the card. FWIW, here is the other side: Imran

All the info you need is in the email I sent. Brian Lamb blamb11@... www.lambtoolworks.com

Oops, I believe I trashed the cart thinking it was marketing BS again.... Bill

Saw this on eshop https://us.feldershop.com/en-US/en-US/en-US/Sawing/Saw-Blades/Rip-Saw-Blade-Flat-teeth-oxid.html $74 and per Brian’ post you might get another 10%. not much but does not hurt.

R. Mike, Sent you a private msg. Imran

got the card at least couple of weeks ago. i feel special. imran

Looking to buy a newer Felder sliding table saw or combo machine, single phase hopefully in Northern CA. ?Thanks! R. Mike B.

Thanks Brian !!

I was asked to forward this to the group from Felder directly, all past customers are considered “VIP”, so it you are looking for the Christmas Discount, here you go... Brian Lamb blamb11@...

I haven’t sharpened any, any reputable sharpening shop should be able to handle it. Honestly, they are not expensive, so I tend to use until they don’t cut well enough and then buy a new one.

I have built two sets of carriage doors.? The first, for my shop, fits into a standard 9' wide by 8' high garage door opening (the original plan for the building was to hold a car). Frame of

Cake versus frosting Plaster versus drywall martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

Jonathan, Absolutely right on the wind part. They make a huge sail. I have pins that I drive in ground on both doors I shared. One panel of the newer door cannot have a pin unless I drill a hole in

This is a staple in many applications where I am correcting inadequacies of standard butt and strap hinges. There is nothing I am aware of that is better performing or easier to work with (or possibly

Hi Bird, With your upcoming build, you're planning on the I-beam for the jamb, right? Actually jambs and header are I-beams. Jamb is bolted to the block in foundation below and then bolted to the I