开云体育

Not exactly sure what you are asking on the DC, you state you will be using the Ecogate and 5” dust pipe, so your main DC. Then why are you asking about using 220V on the Festool? At one point, I

I was just wanting to show the saw, but I know people will pay attention to the surrounding things. ?I have a couple of electric guitars I have not played for quite some time and they need new

I agree, I hated finishing and almost always subbed it out unless it was straight lacquer, conversion or oil finish. If involved filling, staining ect it went out. I only sprayed about 10-20 gal a

The clamping force is directly related to the size of the air cylinders. Those look pretty small in diameter, hence they expect you to run normal shop air, which should be 80-100 psi and the clamps

Your replies were hung for approval. I just cleared them this morning. Not exactly sure why they were hung as you are not on moderated any longer. See if things settle down and revert to “normal”.

Mark, 5 or 6 years ago I went to a 2 day Mohawk furniture repair course, the 2 major things I learned was you can only make a typical repair that is undectable from at most 2 perspectives, the other

I bought a used KF500P saw/shaper recently and was surprised to find there's no brake on the spindle moulder, it takes an age with a big steel block to come to a stop. Now I'm wondering whether there

You would get fired if one brought in any cleaner, polish or lube with silicon in it. I had a problem with it in my shop and had to add fisheye preventer to my lacquer... Regards, Mark

This is very weird. My fourth attempt to reply in this thread.. My replies seems to end up in outer space instead of in the forum.

Hmm. It seems that I'm a little unused to this forum. I have tried to post an image twice, but the post does not show up. Is there anything special I need to do? is there some kind of image quota?

Just ordered a braking module from Germany…I had no intention of buying the whole control unit from Felder! I will give the faulty unit to my mate who is an electronics whizz and keen to learn more

Polishes his guitars with it..

A finisher or refinisher's worst nightmare. Slippery little molecules penetrate deeply into the wood through finishes causing fisheyes and craters along with other problems that can leave you

Yes Paul. I do. I shipped it back. ? In my case the left side table was not same height as the main table in the middle. There is no adjustment for it. Festool response was that it will improve

Roger, So how are you proceeding on your issue. Once we get involved, we also get curious about resolution ? Imran

I don 't kn ow nutin 'bout? the? DC on the Omga thing but I have a? question: What does one do with Pledge furniture spray? in the wood shop? I ask because It's got silicone in it and silicone?

I've just spent the best part of the morning squaring the mitre fenceon a Kapex using Festool's recommended method. Tap Tap Tap re measure---Tap Tap Tap re measure Repeat ad nauseam.I'm probably

If you are concerned, you can always play it safe and add the regulator with a water separator, much like what Mac supplies with the clamps.? It wouldn't hurt anything I don't think

I own a CF-531 and had to chisel about a 1/16th off a tab to clear. ?Otherwise, it fit perfectly. ?He has a good video on YouTube to cut the slot. ?Surprisingly he had arranged to have them CNC’d

I had purchased one for my K500 Pro a few days ago. Just arrived today. It was a little tight on my slider, I had to modify It slightly for clearance. All in all it is nice and worth the money vs the