开云体育

Tom, I sent you a PM, if you are interested in one since Randy’s sold. Imran

Hi David: Good to see you posting on FOG. You’ve been missed. Warm regards, David Lucky Dr David Luckensmeyer Business Manager Luckensmeyer Medical Pty Ltd melissaluckensmeyer.com.au and Designer

No..sorry..It sold in minutes..I was surprised.. Thanks though Randy

I’m ran, the P-channel pressure module coupling including Felder part numbers is documented in this series: https://flickr.com/photos/53698949@N05/sets/72157679368916583 David Best - via mobile

The angle brackets may raise the pressure module too high for your application. Thanks, Chris Perren 512-415-6951

Aigner makes angle brackets that can be used with their regular mounts https://www.scosarg.com/aigner-angle-bracket-i Dave Davies wrote:

Not sure if this helps but Felder has a p channel attachment that can be used with aigner accessories.

Chris, I found this on eshop: Looks like you were able to buy just the part that mounts on the p rail in the item above. I can see why it would be advantageous to have the flat bar. It would allow one

I believe one will work although I just received my Aigner pressure module a few days ago. I’ll test it tomorrow. Thanks, Chris Perren 512-415-6951

Chris, Thank much for quick feedback. Do you need two to support the flat bar in between? Did it come with flat bar? I will check eshop but likely it is still messed up and will have to call in. Imran

Hi Imran Felder makes an p channel adapter that may help. I order a couple from my Felder sales guy. Around $50 each plus shipping. Thanks, Chris Perren 512-415-6951

I did electronic search on survival guide for Aigner and only came up with distometer. I know David Best has machined the p coupling (may be two of them) to accept the Flat bar but are there any other

On my CF741 I have power drive for the shaper only. I have the hand wheel read outs for the table saw and have height set to the only thing that matters to me- dado. The angle readout on the handwheel

I have the power drive option on my K700 shaper, my Exact 63 planer and electronic screen controls on my Kappa 40 table saw.? I can honestly say I don't know what I would do without them.? Not only

Hi Mark: I can speak to your questions in relation to my Kappa 400. It does hold its calibration. Amazingly so. These power options increase my productivity, and put a smile on my face. I do have to

Thank you for the quick replies and info. Brian

K975 manual says to grease the saw height guide every 40 hrs or monthly. It does not mention/recommend a grease type. I have grease for the shaper spindle in the gun. I forget what it is but it was

Around Madison wi a re wind 1/4 or 5 hp is 500.00 I would change bearings also! Mac,,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell 608-824-0023

It’s a standard motor, so any motor repair shop should be able to handle it. It does have external capacitors though, so I would have those checked as well. Brian Lamb blamb11@...

I have been a member for several years but rarely post, usually on every day however, observing threads. I have a 2012 F700z, single phase. Yesterday, while operating the machine, I starting to smell