开云体育

You may clarify if this 90 deg you cannot achieve is in the direction the spindle travels or you are talking about the other direction, that is inline with material feed. I have a diff Felder machine

Richard, Is it a 751 or 741? Do you know what year it t is? Joe in New Orleans

I wondered if anyone has had to adjust their spindle . Mine does not get to 90 with about 1/32 showing at the top of the spindle against a square. Any guidance would be appreciated. Dan

I 100% agree Felder sevice techs are more than disappointing. Regardless if the machine is new i would hold them to it. Play hard ball, be amicable but stern if you are rud or an ass they will ignore

I have a chance to buy a almost new,barely used AD 751 jointer/Planer Extra knives and Mobility kitsingle phase for 7,400 dollars.Would this be worth looking intoany suggestions greatly appreciated

Hi James, Thanks for the info. Unfortunately the setup guide is for the older model A3-31, I think I can see where they differ and where they are the same and surmise how I should adjust this model,

No problem with that set up just be sure to allow for overhead saw guard arm. Dust and electrical come off that side also. Mac,,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi

Welcome aboard, Jeff. My KF700sp's right side is placed against the wall, I opted for 32 inch rip capacity to save the space. The only thing I can see is rough sizing cut is limited because of the

Hello all, I'm a soon to be new owner of a few Felder machines. KF700SP , FB510 and AD741. I've been woodworking about 20 years but have no experience with Euro machines. I have a question about the

Have you checked the A3 31 setup guide from Felder USA website? Maybe you can apply the same procedure on the jointer table adjustment on your C3-31.

Hello, I recently purchased a C3-31 and am a previous owner of an A3-31. I was lucky to receive an A3-31 that was essentially perfectly set up, however my C3-31 arrived completely out of whack across

Mobile, Alabama Thanks for the reminder!

Thank you for posting the pdf. files - much easier than trying to in-zip them. Not sure why I have a problem with it, however you directions were clear. Once again "operator error". Bob

Also, please note that you need to use 7-zip. Normal zip won't work.

Felder has password protected their manual files so you can't edit them. The files are large (around 12 megabytes), and Yahoo limits upload to 10 megabytes. This is why I didn't (couldn't) just upload

You might want to mention where…. Brian Lamb blamb11@... www.lambtoolworks.com

Greetings, I have decided to part with our faithful combo and go to a separate saw, planer and jointer. I bought the machine new at the 2006 IWF. 3 years ago, I converted it to 3 phase using the kit

I have not been able to open the file. I get either "unexpected end of data" or "can not open file as archive". I have tried several options in the 7-zip selections list, and I think I am working in

There is a proper technique and if not followed, the joints can fail. The install you mention might just be lousy installation. I don't recall the specs, but I would not be surprised if there's an

Hi am using some galvanized steel standoffs to PEX today. For a shower mast. I have seen that expansion set up in the last house my son Built and the plumbing company did the work in the cold and a