开云体育

Hi Jim, The 230VAC outlet should measure ~230VAC but since you have automatic start the RL is likely plugged into that unit and that is where you are reading the low voltage. I assume you pulled the

Whether it’s an A3 or my 630 Okoma I size and commonly do that to 10” on edge this is what a sizer is used for to make dimensions S4S. Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave.

Great question, Dave. I am not sure where to find the capacitor or how to diagnose whether it is faulty. I do know capacitors can be dangerous in the hands of the uninformed, like me. Jim James H.

How does the capacitor look? Dave Davies [email protected]> wrote:

My RL125 single phase dust extractor, which has previously worked reliably in both manual and automatic modes, has inexplicably refused to start in either mode.? I have checked the circuit breakers

The same, I was near my planer when I saw the message.

Yes, for the planer. I measured. With it set to plane to an inch. because that is what I was actually doing when I read your original post. Since the planer table descends to accommodate thicker

Great, thank you both! I was thinking it might be a lot lower.

For the planer (thicknesser) not the jointer table?

Posted today, Thanks everyone. https://inlandempire.craigslist.org/tls/d/corona-felder-format4-kappa-400-motion/7778782136.html https://woodweb.com/exchanges/machinery/posts/548091.html PK

Mine lives on a mobile stand. The planer bed is 31" above the floor when set for planing 1" material. I think it is comparable to the shop where I sometimes take lessons where there is both an A3 and

78cm

Hello All, Could one of you tell me the height of the planer table from the floor when you are planing something about 1" thick? Curious to know how it compares with a stand alone planer. Obviously

With push to connect fittings you want to have the end of your tubing, pretty square. At the seat of the push Connect, there’s a small O-ring so when you push the tubing into the collet the tubing

Yeah if you have a reverse osmosis system these are the same type of connections, push in the ring and pull out the hose on all the connections. Even comes with a cutter to make square cuts on the

My email address is at "Fastmail.com". If you asked me for information on my machine, I have sent it to you. So, if you didn't get it, maybe my message is in your spam folder. Sorry I need to send

Will post tomorrow. N/

Pex-B is rated at 160psi - my system is regulated to 120 psi - I would agree that that is not a 3x safety factor but I have had no issues. N/

The easiest and cheapest way to run compressor around your shop is with rubber or hybrid air hose quarter 3/8 half 3/4 with Barb fittings. There is a vast array of fittings. Straight elbow, reduce

Hi Taylor, Are these designed with a push-in connection for the elbow and tee fittings? Can they be taken back easily too? Thx. For sharing. Wade.