开云体育

Wade, I have AD741, I believe the support bar is the same as AD941's. The description on the manual is correct, it is sort of German English :) [image: IMG_3500.JPG] [image: IMG_3499.JPG] James

That would be fine my bushings are on 10 mm increments some longer. You want your package to be tight. Most important thing to pay attention to is everything is clean and no burrs treat these parts

Hello FOG members, Could someone with an AD941 chime in on the proper assembly order for the support bar hardware. ?Felder shows one thing in the manual, but then supplies the bar with these

Thanks for the input, Mac. How about something like a 60mm tall rebate cutter that is a single, solid block. If you had 25mm top hat bushings on both the top and the bottom, would the 10mm gap in the

I don’t know what David does , I have sleeves to fill the space. Example cutter set up that use 4 cutters that are 1.25 or common 40 mm cutters don’t just float in the abyss with no support. I

David B, When buying the top hat bushings, do you have any rules you follow about matching the height of the bushing to the height of the cutter block? For example, if you had bushings that only

Agreed. Why buy both. You can buy groovers for 30mm or 1-1/4. Whitehill sells great adjustable groovers for both bores and they are pretty reasonably priced. wrote:

Sorry to butt in, BUT - I’ve never understood why someone would buy two spindles just to get access to both 30mm and 1?” tooling. Changing spindles is a PITA. Whereas adapting 1?” tooling to a

Hi Ray, there are a few reasons I wouldn’t buy the C3, I went with a B3 & A3 setup 1) the saw rip fence is now the the fence from the K3 Basic, and when mounted on the jointer outfeed table it only

Hi Ray -?? I have a C3-31, the measuring tapes on the floor are an 8' square. I left about 16" of measuring tape on the J/P side, as the C3-41 is a larger machine.

Hi All, What is the minimum workspace size necessary to support a C3-41? Trying to decide if it will fit. Thanks Ray

Thanks Chris and Brian for the Solidworks info. - Scott Hanna

Well, the files you create in the “Makers” version can only be used in the Makers version, you can’t import/export them to other platforms or softwares. You can export .stp or .iges files and

Hi Simon, I can’t tell how far off the part is from “flat” from the photo. But it looks like there may be enough material to machine the part so that it is flat. This might be an option if a

https://www.solidworks.com/solution/3dexperience-solidworks-makers The subscription version of Solidworks is very similar to the full blown version, from my point of view there is no difference. Chris

SimonThe interesting thing is how is something like this missed for 16 years. I don’t know if this is still a current part I would replace as it is Lilly to be screwed up in two axis. Mac,,

Yes, that unfortunately looks pretty severe.

Hi Wade, yes I do mean not flat. Thanks for the clarification. Although we only noticed this because after undoing the hand screws and pulling the extrusion back, the fence was out of square with the

Simon, Do you mean not flat, rather than out of square? Wade

Hi there, We have noticed that our casting on this 2007 cf741s rip fence is massively out of square. Is this by design? Thanks Simon