开云体育

Thank you Keith ________________________________ Sent: March 14, 2021 1:27 PM To: [email protected] <[email protected]> Subject: Re: [FOG] Felder AD 531 I know others have bought

I know others have bought replacements of Amazon. You need to look at the writing on the casing and get the appropriate one.. a search through the posts here might come up with the values. My machines

I think it is a capacitor as this started smoking and popped out of the casing when I engaged the infeed after the motor was up and running at full speed Keith ________________________________ Sent:

Hi Brian I suspect you are right ,I started up the motor and let it get to full speed. then engaged the infeed , this ( I assume it's a capacitor) started smoking then popped out of the casing . If it

Tape measures, pencils and reading glasses, if you have enough of them around, you don't have to look very far. I'm sure I have 7 or 8 tape measures and twice as many glasses. The Milwaukee tape has a

That would be interesting as it appears to start okay. I guess run cap could be bad but I am not aware of noise associated with it. My exposure is limited to reported problems here on FOG so maybe

I suspect he has lost one or both of his capacitors. Did you hold the start button in until the motors reach full speed? Brian Lamb blamb11@... www.lambtoolworks.com

Nope. Unless you come from low to high, the backlash is still there. Their electronic DRO isn’t too high tech, it’s a resolver on one of the gears in the drive train, so any play in the gear train

Brian, You are correct but if I have a preference I would choose a digital display. I guess, I assumed that the lash would also be eliminated. Imran

I like the Stanley lever lock action over the thumb lever.? The end wears out anyway.? Splurge.? Go buy 3.? You'll get 3 times the life and not lose them as often.

Dave, That is good to know. I wish Felder offered it as well. Imran

Keith, The cutterhead would spin for a long while if the brake is not working. With brake it stops in ~8 sec give or take a few seconds. There is also a hum when brake is working. If properly

What do you think the dial indicator wheels are? They are a DRO for the height and angle. Brian Lamb blamb11@... www.lambtoolworks.com

For me, its the power up-down going between jointer and planer and the accuracy of the position read out.? You can dial up a board thickness. On the shaper, its more about position (elevation).?

Hi Jonathan, Not sure how but I was exposed to scraping many years ago. I respect folks who do that. Not only that I do not want to go on that tangent (I don’t really need help in that area ?), I

That's what the Martin T-60 has - DRO with manual crank on the saw as a lower cost upgrade Dave Davies [email protected]> wrote:

I was telling Randy in a private conversation that it would really be a nice option to have a DRO with manual crank on the saw as a lower cost upgrade. I do not know this for a fact but it has to be

Imran, I see a scraping class in your future. https://www.youtube.com/watch?v=pT5KWvglp_c

Hi Imran It is 230v single phase, I do not know how to tell if the electric brake is working. If I disengage the infeed drive , the motor will work just sometimes, but if I remove the drive belt from

Colin If I disengage the infeed the motor works sometimes, but other times just makes a growling noise It is single phase 230v Keith ________________________________ Sent: March 14, 2021 3:51 AM To: