开云体育

ack… closer to 2 times better, so your choice. Neither one are very close when you are talking metal working, but for wood…. Brian Lamb blamb11@... www.lambtoolworks.com

Graduations on the Mitutoyo are 5 minutes, that’s 1/12?, which is .00145” per inch, which by my math is roughly 3 times better than .0035”. Brian Lamb blamb11@... www.lambtoolworks.com

Thanks, is it even possible to set a vernier like the Mitutoyo within that range? Assuming it is calibrated and you are staring at the scale dead on Regards, Mark

That’s (.2?) basically .0035” per inch… your decision. Brian Lamb blamb11@... www.lambtoolworks.com

I have the procedure, is a digital tilt box accurate enough or am I better of using a vernier scale protractor like the Mitutoyo 187-201. Looks like the tilt boxes are accurate within .2deg. Regards,

I have used the Dewalt for years. I love that saw. It’s got a solid little fence that doesn’t flex because it’s locked down at both ends. I use it all the time.

Thanks Joe. Luckily David Best suggested that I keep the stock fence plates when I upgraded, so I still have them. Since I have a router table, I'm wondering if all the switching time is really worth

I bought the on/off switches for K975 on ebay which basically is a mechanical part. For readily available electrical component like the start cap, that I only need one of in a decade I prefer reliable

Since you will give the saw to your dad eventually, then buy the best job site saw, that is a great way to say Thank You. https://www.timberwolftools.com/mafell-erika-85ec-pull-push-saw James wrote:

As mentioned previously, we are about to start the new workshop.? Looking for a stop-gap saw to help with the construction and until I move into the bigger space where I will get another slider.?

Hi Guys, The saw sold yesterday to a really nice guy down on the Cape. ?Excited to have the great saw in a new shop where it will get lots of use. Thanks to all those that helped facilitate this

I find eBay to be a great source for these items with competitive prices and included shipping. Take a look: 50UF 450VAC Motor Run Capacitor 450V AC CBB60 50 UF Round White 50/60HZ Cap (

I think WWTW sells parts too. There might be some prices on the website for comparison. Dave ________________________________ Sent: Wednesday, January 20, 2021 11:50 AM To: [email protected]

I decided to try the guides that came with the saw, the Tannewitz on the upper and the Carter on the lower. I have ordered new wear blocks for the two guides and I have new rear bearings for both.

Bill, if you don’t modify the hood as other described you need to use the Felder plates. I ordered my machine with the Aigner option and they shipped with the Felder plates too. Sent: Wednesday,

Mark, Sorry that you weren't able to purchase a ZCI, but selfishly I'm very much enjoying watching you work though this design. ?Very impressive!

Jack, John Renzetti used to make them. I can sell one for sure maybe both since my KF is a shaper only machine now. I will need to locate them first, LOL Imran

Yes more complicated with auto scoring. For my saw however, scoring is an intentional act it is easy to implement the LED with just the scoring motor control switch. Imran

Where did you get the zci for the KF700?

Hi Greg, Thanks for the details. I do not know the internal design of selector switch so thought may be the old knob is slipping around TDC and the contacts are mid movement position therefore nothing