开云体育

Following up on Assy plus screw for plywood cabinet, I would like to try some new screws for plywood cabinet carcasses.?I called the local Wurth and they only have 2" in stock, but I can order any

Fortunately I wasn't moving too fast or I think I would have sheared off the tip of my finger. I have a new handle to make one of these days to make it safer. The original steel plate had so many

Good point Brian. I have mashed mine on the outside edge of slider as they encountered the beginning of the base extrusion. So tray is a bonus due to a safety feature :) Imran Sent: Tuesday, December

A handle with a hole in it makes it really easy to stick your fingers too low and get caught as you are sliding the table forward. I have a handle and got my finger mashed a good one in there… so

i do not know anything about this machine and likely will go for more https://machinerymax.com/Event/LotDetails/24876793/Jet-JTM4VS-Vertical-Mill many lift tables reasonable at the moment but you

My dust collector remote lives there a good bit... [email protected]> wrote:

per felder Griffchale = handle. i guess it is not a perfect handle ?. there is a lip to grab it however.... imran

This is silly, but I always thought of that as a tray and not a handle. A tray for what I don't know. If it was a handle, wouldn't it have a hole in it? Jason Holtz J. Holtz Furniture www.jholtz.com

Brian – I am in WNY, might have interest in the sander and vfd. Let me know details. Thanks, Ed [cid:image001.png@...] Edward R. Seeley Senior Executive Sales Specialist Cell:

I use this from Felder. https://us.feldershop.com/en-US/en-US/en-US/Extraction/Quick-Connectors/Reducer-quick-connector.html 100mm is about 4 inches.

sure does look the same. good that it works for you. mine is fixed now. plan to replace kip levers with cam levers that Brian suggested. that should make it easy to reinstall to the floater nut that i

I mounted a pvc fitting in my lathe and turned off 1-2mm of material until I had a tight fit. I think I run a 5” hose to the pvc adapter. Patrick wrote:

Imran, looks like the same handle, here are some pics. Might be due to the round over I have in any case no issues taking on/off. Regards, Mark https://www.instagram.com/kessler_woodworks/

This how I have my Hammer F3 Shaper and A3-31 connected https://hosting.photobucket.com/albums/i452/cedwards874/Woodworking/.highres/DustPort2_zpsfyqylx7i.jpg

if this does not fit 120mm OD connector yoh can use short section of 5” hose to adapt to 4”

A few years back, I bought a few from the Blast Gate Company for less than $20 each. They can make any connection you need. Regards, Chris Perren 512-415-6951 Sent: Monday, November 30, 2020 5:03 PM

can you use 5” hose instead? it should fit 120mm OD. imran

I 3D printed mine. If you are in Canada I can print one for you. Envoyé de mon iPhone

A while back I think I saw mention of a source for DC adapters, but can't locate it. I have a jointer output port that's 120MM o.d and I need to connect to 4" flex hose. Any pointers on where to go

There is a more recent one with Betty White that is on utube as well. Sent: Monday, November 30, 2020 11:46 AM To: [email protected] Subject: Re: [FOG] Last Call for Slider Nuts That was