开云体育

Only works for me from my cell and only copy martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell 608-824-0023 fax airtightclamps@...

Having tested (visually, not scientifically) a couple dozen or so LED bulbs, I'd agree that CRI is not a guarantee of subjective light quality. For example, I find Sorra 80 CRI bulbs noticeably better

On LED versus Florescent please do some reading on the light spectrum. Color temp is very misleading. CRI is a better indicator but not great. The lighting industry has been trying to create a new

I thought if I copied and pasted a picture in my post it would show up, but it did not. I added a photo in the photos section showing the shaper-router table "combination machine".

My solution to the router bit problem. I considered not having a router table when I got my shaper or having my shaper be the router table. Then, after receiving mixed feedback on the spindle speed on

Damn, I should have proof read my last message. Corrected below.

John, Is correct. The fence and hood not he Profile X-motion will not move back far enough to use small router bits. With router bits the reference point for height will vary for profile bits. Using a

Glen, you typically can't bury a router bit full depth in a collet so using a computer could be a problem. Plus there is a lot of variances from manufacturer's. I ?thought you had mentioned the

Paul, this doesn’t sound Welch to me: https://www.youtube.com/watch?v=CWM8w18WrP0 <https://www.youtube.com/watch?v=CWM8w18WrP0>

Glen, I’ve been thinking about the challenge of using the xMotion positioning controls on the Profil 45 for programmatic storage of router bit setups. I suppose it’s possible to come up with some

I cut a length of dowel to jam between the machine side and the lock button in the locked position. Leaves two hands free for that spanner. One to hold it flat on the collet and the other to unscrew

Glen, Regards programing data with a router cutter. If a router cutter will not bottom out you could use a small spacer between the bottom of the chuck and the end of the cutter, a small piece of

Brian I did not even think about access, was only thinking about the heat aspect, I total get what your saying. Glen

OK David Thank you for you being you and everyone else here. I am learning so much from you all I will make the road trip up and just pick up yours. LOL That is a really nice setup and I will total

Thank you Mac Thats what I am starting to figure out too I do want to get my air clamps from you and will be talking to you when I get to that point. How I can take a little wood shop and make it so

Hi John Ok this is something I did not think about. I am getting a Profil Z X motion. I am getting the understanding about setting the cutterheads and programing them in the data base but I really did

I spent some time wandering around with a light meter and have some observations from 62 year old eyes, glasses of course. 10 - 20fc. Typical light found on the interior of many job sites. Not enough,

Glen, here’s where I got my wire rope & gripples several years ago… Alan Manufacturing Inc. 3927 East Lincoln Way Wooster, OH 44691 (800) 435-2526 Fax (877) 333-2526 Customer Service Hours Monday

The photos are here: Yahoo! Groups http://tinyurl.com/hvstkxq http://tinyurl.com/hvstkxq Yahoo! Groups http://tinyurl.com/hvstkxq Oops! Sorry, an error occurred while loading the content. View on

ME TOO. I have four new three phase machines coming and have single phase and against my will have to put in the converter too MY electric company will up grade the lines on my street for me and big