Hi Neil,
Do you have any pictures you could share showing the various fittings used with the Pex system?
Thx,
Wade
toggle quoted message
Show quoted text
On Aug 24, 2024, at 7:21 AM, Niel <nv@...> wrote:
?
My two cents,
I have to second using PEX - I use 3/4, I have around 60¡¯ with 5 drops - key for me was buying the Ryobi crimper for the Stainless rings - use it for all my plumbing/ hydronic heating and air connections I have made 500+ connections and truly cannot recall a leak on any. I have cable trays across the shop ?drops from their to the machines is a pex T to pex - to NPT thread + Quick connect or a faucet pex connector with screw flange.
A second point someone else raised is that I have two California air 2HP compressors (10 Gallon tanks) they sit next to each other. For normal use I only use one, if ?sandblasting I turn on both. They are connected to the airline system through two check valves (nomalising pressure).
?N/
On 16 Jul 2024, at 12:54, David Davies <myfinishingtouch@...> wrote:
Or just get another small compressor and put it right by the slider.
Do not use black pipe !
Dave Davies
On Tue, Jul 16, 2024 at 11:52?AM netanel.belgazal via <netanel.belgazal=
[email protected]> wrote:
So far I only use my air compressor for small things like pin nailer and blowing dust.
I ordered mac clamps and I need to distribute air across my shop.
I wonder if you have any recommendations on air hoses/manifolds/fittings?
-- Dave & Marie Davies
318-219-7868
