Re: SCM FS 41ES/52ES
¿ªÔÆÌåÓýVery nice. Felder better get their act together and ship machines that work straight out of the box. I do not recall making any adjustments to my 2002 KF700. So not sure if we hear the bad news here but not as many success stories.Since they machined holes at the ends of jointer tables they must work with some system. I use ext. tables all the times and do like to leave the 500mm one on planer outfeed. Allows me to casually catch the long pieces. BTW, if you dimension board width on the planer check out if you roller support will go low enough for a 6¡± or 8¡± board on its edge. I had to cut the inner telescoping tubes (roller is mounted to this) on 2 of my rollers to ensure they will go low enough. Imran Malik On Jun 14, 2024, at 7:47?PM, Brian via groups.io <brian.milidrag@...> wrote:
? Hi Imran, The finish is as good if not better than any I¡¯ve seen. Once I got the Cosmoline off I used a green scuff pad and a random orbital with WD40 on all three tables. That really did the trick!? <IMG_0558.jpg> There are Two holes machined on both infeed and outfeed tables but not on the planer table¡not sure what is available from manufacturer or tier two suppliers. I could not find anything from the manufacturer. On Fri, Jun 14, 2024 at 6:59?PM imranindiana via <imranindiana=[email protected]> wrote:
|
imran