Wait a minute¡. You seem to be mixing inches and metric. Two and a half divisions on a .0002¡± per 10¡± level would be roughly .0005¡± in 10¡±. That is roughly .012mm in 250mm. I don¡¯t know how close you want, but that¡¯s pretty damn good.
Brian Lamb
blamb11@...
www.lambtoolworks.com
toggle quoted message
Show quoted text
On May 8, 2024, at 11:24?AM, netanel.belgazal@... wrote:
The middle bolt is also available on the K3 slider line.
After leveling the machine with
After adjusting the leveling feet and let the saw rest for a day or so, the cast iron top moved a bit. I did a minor change and now I can see the rip fence edge is 2.5 division lines different than the? edge close to the slider.
(2.5 division lines * (0.0002''/10" * 12") ~0.6 thows. Is that good enough or should I aim for higher tolerance?
