Re: AD741 stuck outfeed table vintage 2006
¿ªÔÆÌåÓýAllen, Yes, the travel is much limited on the outfeed. I believe it is less than 0.100¡± total, as the purpose is to align the outfeed to the circle of cut. It is also very fine allowing one to make adjustment down to 0.001¡±. The infeed in contrast adjust by 6-10 mm - not sure what the max depth of cut is on your machine. Hope this is helpful. Imran Malik On Mar 25, 2024, at 4:23?PM, Allen Wolfenden via groups.io <a.wolfenden@...> wrote:
?Imran thank you for the response. The attached photo shows the degree of rotation of the bar on my infeed table and is about 30 degrees of rotation from the lowest to high position. Is this visual reference different between the infeed and out feed table adjustments? thank you Allen? <IMG_0026.jpeg> |
imran