Hi Nathan,
Over a year ago I was also playing with that idea and whipped up a quick prototype as can be seen in the picture below. It is/was the goal to make some 3d printed parts and use the VEIKO T ruler () To date, I didn't spent the time to get the design forward. Currently I am just using a stop block that I fix with an F-clamp. I fixed it on the top T-slot as I have my doubts about the strength of the side mounted T-slot when it comes to being loaded with a 60-70 cm plywood panel. Does anybody have experience with load capabilities of the side of the sliding table on a Hammer?
Regards
Bram
