I have been selling for years now, parallel fences to fit the Hammer and Minimax machines that bolt to the t-slot in the side of the slider. I do limit the width to roughly 25¡±-26¡± of support and no issues that I have ever heard of. I would not hang the Felder 1M extension on any sort of adapter on the Hammer slot arrangement, that would be asking for trouble.
Brian Lamb
blamb11@...
www.lambtoolworks.com
toggle quoted message
Show quoted text
On Jun 27, 2023, at 10:50 PM, bram.baert@... wrote:
Hi Nathan,
Over a year ago I was also playing with that idea and whipped up a quick prototype as can be seen in the picture below. It is/was the goal to make some 3d printed parts and use the VEIKO T ruler () To date, I didn't spent the time to get the design forward. Currently I am just using a stop block that I fix with an F-clamp. I fixed it on the top T-slot as I have my doubts about the strength of the side mounted T-slot when it comes to being loaded with a 60-70 cm plywood panel. Does anybody have experience with load capabilities of the side of the sliding table on a Hammer?
<20230628_073452.jpg>
Regards
Bram
