If it¡¯s not running straight, then it would be Felder¡¯s responsibility to fix it. I don¡¯t honestly think that I¡¯ve ever seen a slider (that wasn¡¯t damaged) that didn¡¯t cut straight with less than .1mm, so I doubt that the slider is bad.
Brian Lamb
blamb11@...
www.lambtoolworks.com
toggle quoted message
Show quoted text
On Mar 15, 2023, at 7:56 AM, DanielD <dan@...> wrote:
@Brian
Hi Brian. I will definitely try your test this afternoon...
I did centre the riving knife with some shims on the back of the mounting block, and the mdf was clamped in place with the Felder eccentric clamp.
I looked at some videos and I see there are bolts to adjust the slider angle- except what to do if it is not running straight?
Cheers
Daniel
--
Daniel Day
Kitchener, Ontario, Canada
