¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io
  1. Felderownersgroup
  2. Messages
Single Messages Topics Expanded Polls

Re: Automatic blast gate issue #k700s

 

¿ªÔÆÌåÓý

Wade,

You may first see if there is a current trim screw. That would make your job much easier.

Since it is a saw only machine you do have a choice to go to the motor with single sensor. However, my preference would be to place it in the electrical cabinet away from dust and vibration. Again, you need to contact Felder if you are going yo access the electrical cabinet.

Imran

On Feb 9, 2022, at 2:56 PM, Wade Dees <wjdsignature@...> wrote:

?
Thank you Imran & Steve. ?Your onto something here. ?I¡¯ll get a longer phone cord and try to locate this sensor inside the cabinet of the saw. ?And install onto a cable that leads just to the motor.

Thank you!

Wade

On Feb 9, 2022, at 4:58 AM, Steve Wurster <steven.m.wurster@...> wrote:

?GrnGate has apparently ceased operations, although their website is still online for support reasons.? Looking at their manual I see the following:

NOTE: Some power tools including the SawStop table saw and certain European tools have an electronics control system. In these cases the sensor must be attached AFTER the control box, ideally directly on the cable going to the motor. Otherwise it is possible to incur erratic sensing and collector operation due to a constant current being drawn by the control system.
So perhaps you need to change where that sensor is placed on your machine.

Join [email protected] to automatically receive all group messages.