Re: Automatic blast gate issue #k700s
¿ªÔÆÌåÓýThat was a bad example as the coil is on T3 of the PP and there may not be any current on T3 when I adjust the table. Still I think it is a good sensor. You get the feel for it¡¯s sensitivity as you play with the set screw and see the lights which indicate drop in and drop out of the relay. Imran On Feb 9, 2022, at 12:07 PM, Imran Malik <imranindiana@...> wrote:
? I also have a home made auto start dust collector system. I use it with KF700, Dual51 and K975. I have a single pickup coil installed inside PhasePerfect that is dialed in for the smallest motor (3KW - KF700). No DC startup when I adjust table height on Dual51 or blade height on K975. I use this coil, was around $20 few yrs ago. This requires the wire to be disconnected and routed thru but there are also open core models that are clamshell style and are easier to install on difficult to remove wires. Here us a short video of Dual 51 table movement with no dust collector trigger. Imran On Feb 9, 2022, at 11:47 AM, mccrery@... wrote: ?I use a custom-made automatic blast gate dust collection system. ?I recently replaced my jointer with a Felder AD 741; both the blast-gate & dust collector operate only briefly when the 741 is switched on. ? A similar issue? ?Adjusting the pick-up coil was not helpful. ?Thanks, Jerry |
imran
