?Hello.? I've been experiencing exasperating problems with the start function on my machine. I can now probably write a book about this, but suffice to say that when the selector switch is set to Table Saw, the machine fails to start.? I've worked quite a bit with Phillip Dingus at Felder.? He's been a champion, but we've failed to figure out what is happening.? I sprung for a whopping $700 to buy a new selector switch, which I meticulously installed, terminal for terminal, wire for wire, with zero effect.? The machine will start when set to J/P and Shaper, in forward or reverse, but any time the selector passes through TDC (which is the Table Saw), no machine will subsequently start.? I am wondering if there is anyone in the group who is sufficiently wise in the ways of electrical engineering to help me through the wiring diagram to perhaps pinpoint what is going wrong.? I have also traced every single wire in the machine, and compared the "as-is" wiring to the wiring diagram furnished by Felder.? There are some anomalies, but the machine worked flawlessly as wired for 19-1/2 years, so...go figure.? Any ideas of where to turn?? Thanks!? Greg