Re: Hammer C-31 Planer Issue - Motor Triping
¿ªÔÆÌåÓýAnnu, Thanks, that is all i wanted to confirm. Here is a good example of not to have any power on the motor. I am surprised they did that considering I see all 3 phases being switched in my saw. I guess they have to save money somehow to lower cost. Imran On Jan 13, 2021, at 7:55 PM, annu.marwaha@... wrote:
? [Edited Message Follows] Hey Imran,I thought of that too. ?But if that was the case, then the shaper and table saw would do the same thing when plugged in the motor connector that is for the planer position. ?However they worked fine. ?On the flip side, when I plugged the planer motor in the shaper position, it did the same thing. ?I think one of the spots is always hot. -Annu |
imran