Last Call for Slider Nuts
¿ªÔÆÌåÓý???I thought a new thread may help in accessing needed info in one place. Please let me know by tomorrow, Monday Nov 30th if you are in need of a slider nut for your Felder. made out of CR1018?flat bar stock,?0.5¡± high, 1.25¡±?wide and 2¡± long. i expect the height and width to meet +0/-.004¡± tolerance. the length will have slight variation as it is marked and cut on a bandsaw. you can specify any length at $1/in for nuts over 2¡± in length. if shipping is affected i will let you know. you need to let me know if your machine is xroll or the model before xroll. i am not certain if it would work for older felder models but one member has measured his BF741 and apparently it will fit if bottom long sides are chamfered. i cannot guarantee compatibility with non-felder machines. one tapped hole of your choice in the middle of the nut from std offerings up to M8 or?5/16¡± and associated coarse thread. i will entertain your need outside what i have listed above as long as i have the tap, just let me know what you need. 1 for $25, 2 for $40 and 3 for $50 shipped to lower 48. please select ¡°reply to sender¡± below if you are interested. here is a pic of the last one i made. imran |
imran