On Nov 29, 2020, at 9:45 AM, imranindiana via <imranindiana@...> wrote:

???I thought a new thread may help in accessing needed info in one place.

Please let me know by tomorrow, Monday Nov 30th if you are in need of a slider nut for your Felder.

made out of CR1018?flat bar stock,?0.5” high, 1.25”?wide and 2” long.

i expect the height and width to meet +0/-.004” tolerance. the length will have slight variation as it is marked and cut on a bandsaw.

you can specify any length at $1/in for nuts over 2” in length. if shipping is affected i will let you know.

you need to let me know if your machine is xroll or the model before xroll. i am not certain if it would work for older felder models but one member has measured his BF741 and apparently it will fit if bottom long sides are chamfered. i cannot guarantee compatibility with non-felder machines.

one tapped hole of your choice in the middle of the nut from std offerings up to M8 or?5/16” and associated coarse thread.

i will entertain your need outside what i have listed above as long as i have the tap, just let me know what you need.

1 for $25, 2 for $40 and 3 for $50 shipped to lower 48.

please select “reply to sender” below if you are interested. here is a pic of the last one i made.

<image0.jpeg>

imran

On Nov 29, 2020, at 4:05 PM, david@... via groups.io <david@...> wrote:

?Did someone say T-nut?

<IMG_1332.jpeg>

<IMG_2651.jpeg>

David Best

https://www.instagram.com/davidpbest/

On Nov 29, 2020, at 9:45 AM, imranindiana via <imranindiana@...> wrote:

???I thought a new thread may help in accessing needed info in one place.

Please let me know by tomorrow, Monday Nov 30th if you are in need of a slider nut for your Felder.

made out of CR1018?flat bar stock,?0.5” high, 1.25”?wide and 2” long.

i expect the height and width to meet +0/-.004” tolerance. the length will have slight variation as it is marked and cut on a bandsaw.

you can specify any length at $1/in for nuts over 2” in length. if shipping is affected i will let you know.

you need to let me know if your machine is xroll or the model before xroll. i am not certain if it would work for older felder models but one member has measured his BF741 and apparently it will fit if bottom long sides are chamfered. i cannot guarantee compatibility with non-felder machines.

one tapped hole of your choice in the middle of the nut from std offerings up to M8 or?5/16” and associated coarse thread.

i will entertain your need outside what i have listed above as long as i have the tap, just let me know what you need.

1 for $25, 2 for $40 and 3 for $50 shipped to lower 48.

please select “reply to sender” below if you are interested. here is a pic of the last one i made.

<image0.jpeg>

imran

?

That was always my favorite time frame for SNL.? Thanks for the laugh.