I agree, nice job.
Lately, I¡¯ve been using dowels for mitered corners on cabinet doors - easy with the DowelMax jig.
I wonder if 4 dowels per corner would work for this project? There is no shifting as with the Kreg jigs. This is easier than you would think.
toggle quoted message
Show quoted text
Imran,
Sell your Kreg pocket jig (I have to say it is a defective?product by design) and buy Castle 110??:)
James
On Fri, Nov 20, 2020 at 2:43 PM imranindiana via
??<imranindiana=
[email protected]> wrote:
i made these mitered frames to wrap pressure treated porch posts
i made one 45 cut and then instead of setting the xcut fence to the opposing 45, i flipped material 180 lengthwise and made the opposing cut with material upside down. i could not do that with KF700 because it does not have scoring. this is probably a std practice but new for me.
even though miters were perfect i did get occasional height variation on assembly with kreg pocket screws. this is with predrilling the opposite side and best clamping i could do. so not sure if i can improve it any more.
imran
