开云体育

I've been meaning to do this mode with a PCV valve off some other car for a while since I don't like all the oil coming into the intake and making a mess. However, I'm not sure our 2000 eurovans

I am in need of an OEM 1993 Eurovan distributor.? I bought an aftermarket, and it worked for a short time... then failed. Anybody have one, even used?? Or know a good reputable source?

Has anyone replaced their house battery with something like and Ecoflow? https://ca.ecoflow.com/products/delta-3-series-portable-power-station?variant=45159091077274 That one is 15.7 x 8.3 x 11 in /

Try lubricating it with WD40.

I've never paid attention to it but on my 02 mv Should the hook on the sliding door reinforcement plate- 701809284C - be able to move around? I can wiggle it some and the door makes a snapping noise

I decommissioned the switch on the panel, but I did keep the switch on the back near the sprayer operational. I think that when I added the relay, I wired battery +12v to two prongs, battery ground to

I would be interested in this as an option. I am not sure if the faucet is fried as I am still drawing a short when the faucet is clicked on, but at this point I will likely be re-wiring the setup

I did test the faucet as you described. I’m no expert, but I was getting 0.0 when off, and then when faucet was turned to the on position, I received a readout, I believe around 2 ohms sounds right,

When I swapped out my faucet for the Shurflo upgrade, I added a relay switch to the system to avoid running continuous current driving the pump through the faucet itself. If your faucet is indeed

I second Joshua's suggestion. That was the issue with mine, corroded/poor connection at switch. Pete 2000 EVC, ~210k miles

Have you checked that the switch in the faucet is good? You can do this by disconnecting the wires to the faucet, and connecting an ohm meter to the wires. You should see open circuit when the faucet

Hello folks, We have been in this group for so long and have found information helpful to our Eurovan questions. After 10+ years with her, as we have spent less and less with her, it's time to let

I upgraded the original faucet to the shurflo electric faucet (included with 97 and later). I had it wired up with one of the blue wires connected in to the middle pole wire on the back of the monitor

Ron, I appreciate the quick response.? I am a little bit nervous about the aftermarket injector.? But it does sound good.? I may need time time to digest that.? I do know that a lot of other

That is for sure an option.? I know for sure one is bad, and I may do this once I get it apart to see what I am working with.

As an alternative, we have aftermarket ones for half the price ($59 each, so $354/set). If you email me directly I can give you an additional 5% off discount code, bringing it down to $336 . We've

maybe send them to someone who cleans and services them?? I sent my Vanagon injectors to Mr. Injector in Idaho and they were tested and cleaned and are still running well 10's of thousands of miles

Good morning all, I have a 99 with VR6 12 valve AES engine.? I had a fuel injector crap out on me over the summer.? I have pretty much quit using the van since then, but I need to get the van back

Spot on! Took me forever to figure out what was happening when G22 failed (7 years ago)... Vehicle goes into Limp Mode because of erratic data off G22 doers not correlate to Tranny speed G68...?

working on replacing driver side wiring harness but am snagged on removing fuse box off the holding brkt. I have unclipped the two holding clips and can lift the right side of box out of the cradle