Mike,
What are you using to scan with? You might stop by an Autozone and see if they can scan it.
Steve
636-337-7700
888-797-5994 - order desk
toggle quoted message
Show quoted text
On Jun 20, 2008, at 4:26 PM, vweuro00 wrote:
my check engine light is on and i'm getting no signal to the OBD II
port. i checked the wires going to it. two of them are ground wires
that both have a good ground. one has 12v going to it and that one is
fine. the other is the gray/white wire. i'm not sure where that one
goes to. the bentley manual shows that it goes to the radio. that
doesn't seem right to me. at any rate, i'm two months past my
inspection now as i've been trying to figure this out. i'd love to get
any ideas.
thanks
mike
