I just purchased the same thing. I found that the bottom two snaps
fit better if they are towards the middle of the van a bit instead of
being at the corners of the hatch opening. However, if you locate the
snaps low, you will pinch the cloth if you close the hatch with the
screen in place. I ended up installing two more snaps further up on
the plastic walls of the battery and electric panel compartments (and
used snaps with machine screws instead of sheet metal ones). I have
so far only installed the two snaps at the bottom and will see if I
can get away without the upper snaps.
Lin
--- In ev_update@..., "illinirocketscientist"
<websailn2@...> wrote:
I purchased a Winnebago rear hatch screen from a dealer's old stock.
The screen is new, but there are no instructions (or snaps). It
shouldn't be too hard to buy some snaps and manually locate them, but
if anyone has the instructions and would like to post them in the files
or e-mail them to me, it would be a helpful starting point.
I did find some photos/suggestions in the "Links" section, and these
will probably be good enough. I gather that the instructions may not
be that acurate.
Regards,
Duane
2000 EVC
