开云体育

Of course, you can always install the Rocketronics.de ELS and that will take care of any feeds, threading, taper, and radii cutting. Best Regards, Andrei mailto:calciu1@...

Of course, you can math the thing out if that is your strength Regards Vedran

If you have the dial indicator at least similar to the one I posted, then you'll need to multiply/divide the numbers by two but in general it should work. If you have a single gear thread dial than

Hi Manolis (?) Trying to figure out what’s what with the thread dial indicator for a V13 according to the manual Did you get the indicator with the lathe or add it afterwards ? Can you maybe take a

You are welcome to them. Erik <cvarenhorst@...> wrote:

I am interested, count me in after Erik takes a swing.

My lathe has a 6mm pitch

Hey Roman, I used CA glue (aka super glue). One thing I will say about the original gears, when I was pressing them off of the splines it took a decent amount of force before I felt a pop, which I

Hi Vedran I am not familiar with the V13 so maybe one of our members who has one can help I have a couple of spares lists for it . . the one doesn’t show the thread dial indicator at all , while the

Hi Rey, thanks for sharing your work on the gears, the gears look really good, I would like to ask you what kind of glue did you use to stick them to the original spline center? I am curious how the

dunno about v13but this is the one for s11 if your leadscrew has the same 3mm pitch and your dial has 14, 15 and 16T gears than this should work good luck [image: S11-threadingdial.jpg] Regards Vedran

Seems the last bit of my message got cut off... Not having a good day with all these attachments. Anyways, moral of the story at this point is that things are working so far, but I'm not ready to

Continuing Gears went into the headstock, it was a bit of an adventure getting everything back together, but in the end, everything worked out. Fit is smooth and everything turns without binding or

Update time - the gears have been printed, lathe reassembled, and so far so good. After several weeks of not being able to use the lathe, it is finally back in good running order, this time with all

Hello. I have in my possession an EMCO Maximat V13 lathe and I have the original thread dial indicator. My lathe is metric, and I do not have the small chart for the thread dial indicator. Does anyone

LMS has a smaller table. https://littlemachineshop.com/products/product_category.php?category=1034788869 Chris P ________________________________

Hi Andrei See attached , pages 51 to 54 Regards, Carvel From: [email protected] [mailto:[email protected]] On Behalf Of Andrei via groups.io Sent: Friday, March 28, 2025 7:21 PM To:

Sorry, I was thinking of the indexer used on a Compact 5 and Unimats. Those are such different devices than a rotary table or dividing head. Best Regards, Andrei mailto:calciu1@...

Regards, Carvel From: [email protected] [mailto:[email protected]] On Behalf Of Andrei via groups.io Sent: Friday, March 28, 2025 4:26 PM To: [email protected] Subject: [emcoV10lathe]

I am curious about how that device works. Can anyone share some information or a video? No, i don't have one, but I have seen a lot of them for sale and I am always wondering. I have a real dividing