Re: Emco maximat v 13 thread dial indicator chart
|
If you have the dial indicator at least similar to the one I posted, then you'll need to multiply/divide the numbers by two but in general it should work. If you have a single gear thread dial than you won't be able to cut most of the pitches. Also check how many teeth your gear has, if it's not 14,15 and 16T you'll also have some conversion factor to apply. You should pick one of the more convoluted combinations and try what you get
Hi Manolis (?)
Trying to figure out what¡¯s what with the thread dial indicator for a V13 according to the manual
Did you get the indicator with the lathe or add it afterwards ?
Can you maybe take a picture of it for us ?
Many thanks
Carvel ? From: [email protected] [mailto:[email protected]] On Behalf Of manolis sikalhs via
Sent: Sunday, March 30, 2025 6:18 PM
To: [email protected]
Subject: Re: [emcoV10lathe] Emco maximat v 13 thread dial indicator chart ?
|
