Re: What kind of fitting is this?
|
Ryan, you'll need a machinist to turn this shaft into a diameter that fits the toothbelt pulley, and a key slot, made for same.
Or ask the manufacturer of the motor if they have any straightforward recommendations for you.
Carsten
On Thursday, 27 May 2021, 01:12:28 GMT+8, Ryan Sweet <ryan@...> wrote:
Argh accidentally hit send instead of paste - something like this - ideally with a toothed belt pulley instead of smooth.... any thoughts on the best sources for that?
On May 26, 2021, at 10:10, Ryan Sweet <ryan@...> wrote:
?
enter gearsomutions.com for helping me get educated.?
So it looks like I would need something like this...?
On May 26, 2021, at 09:57, Ryan Sweet via groups.io <ryan@...> wrote:
?
Thank you! That was what I needed to learn more.?
Any recommendation for a reference work that can fill these occasional gaps in my understanding of mechanical connections? On May 26, 2021, at 09:49, Dan Pfeiffer <dan@...> wrote:
?
Its a spline.?? Very common on transmission shafts.?? Allows for a slip fit and very high torque capacity.??
?
On 2021-05-26 11:40 am, Ryan Sweet wrote:
Hello,
I am evaluating an EV kit and I see this shaft on a drive motor... notice the female toothed grooves in the shaft... and I¡¯ve not seen this before nor can I figure out what it is called.
Does anyone know the right way to describe this kind of fitting and what the corresponding male part looks like (say, for mounting a pulley)?
Thanks,
-Ryan
|
