开云体育

Hello Bob and thanks for the reply! pavucontrol is showing up normal just as before: rigctl -m 2 is working I believe: You're probably right about the delay, I adjusted the config file to 30 instead.

It's a little more complicated that that. I can direct the audio out from SDRconnect to other applications such as WSJT-X and QSSTV. Direwolf requires it's own audio stream, and not a shared one.

Hi Cass I assume that pavucontrol Recording tab shows PCM2901.. and the input level display is stuttering at least halfway up the scale on no signal? Also check it isn't muted (the red crossed speaker

Historically I suspect you where either plugging the Yaesu's headphone jack into the microphone or line input of a PC sound card, or using some other sound card interrace. Since the audio processing

Well hello again, everyone... Everything was working pretty well- After my last message here, we had been focused on working on other aspects of the ground station: openC3 COSMOS integration, docker

Hi, I think I just successfully built and installed Direwolf on my Mac, following the instructions in the user guide. According to the guide, to run direwolf, I just need to run

Phil, I may be wrong about this, but I Think that once SDRConnect is up and running, it assigns itself to the PC's sound playback system. Once assigned, it is not available for other use like

Hi John - Latest "get checkout dev", "git pull" by git etc - Toshiba i5 laptop 8GB RAM, orig p/n Satellite P500/003 PSPGSA-024003 - Debian Bookworm up to date patched. I do a lot of build from source,

ONE_BUF_TIME is roughly the number of milliseconds of audio samples in one audio input buffer. So, in this case, there would be about 1000 / 10 = 100 buffers per second from the operating system to

Kind of asking John WB2OSZ What please is the significance of? // Originally 40.? Version 1.2, try 10 for lower latency. #define ONE_BUF_TIME 10 in audio.c (also in the portaudio and windows audio

I know this is a busy group so thank you for reading this. It's been quite some time since I've played with packet radio so I've probably overlooked something obvious. When I last used my Yaesu radio

A little bit off topic. I have been chasing down an audio buffer underrun problem that only happens with direwolf. I am also running pulseaudio despite not being a good idea for direwolf! I am making

Hi, The Icom 9700 stops transmitting as soon as the PTT signal is dropped, but it does have some delay in its audio processing. This means that you need to increase TXTAIL in direwolf.conf in order to

I am on the right station - checked and double checked, even tried other stations with different frequencies. It is always the same. ?I do see APRS data but no AX.25 connect.

Those are connection attempts transmitted.?? There is no reply. Can you hear anyone else talking to VA7QBE-10 ? Are you on the right frequency?? Are the winlink stations using 1200 bps AFSK or

I have spent quite a while trying to figure out why I cant get direwolf to connect to any AX.25 nodes. It starts up fine and sees APRS traffic but if I try to send by packet in Winlink or connect to a

That is what I was suspecting. This evening I had a few mins to make some changes and send the third party packet in its string representation. Yet there is still something a little off. [15.is

This part needs to be in plain text, not the AX.25 header format with the characters shifted left.

I have been doing some reading and experimentation this morning and have a theory. Hopefully you can confirm my theory. I am using a forked copy of the ioreth script (actually forked copy running