开云体育

I have an ICOM 9700 connected with a USB cable. I setup direwolf per the instructions for CM108. I tried to test my configuration with direwolf -x a and got the following message. ** Reading config

I bought it on Amazon Japan. I connected it to a USB port and it was recognised as a speaker, microphone and serial interface.? The devices that have been added to the PC are circled in green. I

Hi David, Bob, If I may chip in with my experiences gained from running a 30m BBS for a number of years. My comments are further down ...

Hello Bob, Ah... Ok, got it and yes, there seems to be some confusion here around terminology On page 61, the User Guide says: -- My original solution for this, many years ago, was to allow

Hi David No possibility with an antenna change hi. What confused the issue with 9.2.2 is the table of modems says; “+” means enable multiple slicers. “-“ means single slicer. but one

Thanks Jeff Might also be worth experimenting with the various fldigi modes "made" for varying HF condx. I found the PSKR (ie BPSK with FEC) quite useful in that starting with the same base mode and

There's also the relatively recent IL2P mode which is supposed to be even better than FX25.? I haven't tried it yet, but a couple of us just today started experimenting with Direwolf/Soundmodem modes

Hello Bob, Your #1 best way to improve 300bps AFSK packet is a better antenna on your side. I do completely understand that this is the hardest thing to do though. Ultimately, the 300bps AFSK mode

Have been going through the docs on this and now decoding quite weak/noisy signals, quite interesting. Want to make sure I have covered everything else that "may not be documented". Most of the 14105

That's fantastic, John, thanks!? You rock!? I'll explore this. 73, Steve KF8KI

This is very easy but you will need to use direwolf version 1.8 which is currently the "dev" branch. Simply add this to your configuration file, using a virtual channel number in the range of 6 to

Thanks again David, I will be getting into 10 meter soon and taking a break from VHF direwolf, but I will keep all these emails in mind for when I need them. [email protected]> wrote:

Hello Maxwell, Adding to Thomas's excellent points, I can add: Try following the "The No-Test-Equipment Packet Adjustment System" section of https://www.febo.com/packet/layer-one/transmit.html and

T

Hi Maxwell, I'm using Direwolf (version 1.7) primarily for "connected mode" sessions and I can confirm that it does handle those very well. I only remember two instances were Direwolf failed and in

Hello Jeff, There is the very basic file at https://github.com/wb2osz/direwolf/blob/dev/CHANGES.md and there is a per commit overview at

Hi David, Is there a changelog available for the 1.8 version?? I checked the github site but didn't see one. Thanks, 73

Hello Maxwell, I would recommend to try Direwolf 1.8 from the develop branch. It's basically complete at this point and has lots of improvements since the v1.7 version that was released on Oct 28,

Hi Max Not really a direct help to your issue, but I had a strange problem IPV4 vs IPV6 with paracon/direwolf and ended up changing to QtTermTCP for further experiments.. It also talks AGW to