开云体育

Since there is a message in your startup screen shot that says "...
Note: PTT not configured for channel 0. (Ignore this if using VOX). ..."

I'd say you are either NOT using VOX, or your VOX is not configured to
key the radio properly.? A common VOX configuration issue is typically
that the audio level for VOX to trigger the PTT is higher than the TX
audio for good packet transmissions.? On some interfaces, this can be
adjusted by increasing the sound card output, but only of there is an
adjustment (pot) between the VOX input and the Radio input.? Increase
the sound card, and reduce the level going to the radio with the POT.

Robert Giuliano
KB8RCO



On Monday, March 15, 2021, 12:33:12 PM EDT, rodneymyers60 via groups.io
<rodneymyers60@...> wrote:


[Edited Message Follows]

hardware used

rpi3

direwolf

leixen vv-898 (serial cable purchased)

usb soundcard
<>



Following this video <>



attempting to get aprs iGate & digipeate working



With the video as a guide, I can receive packets & iGate wit no issues.
I can also the receive light on the radio (green) when it receives.



Transmitting packets on the other hand does not happen.

?

I figure I’m missing some configuration settings, but no idea where to start

?

Not sure what other info would be of assistance.

This is what I see when direwolf starts