Hello
?
Okay...tried the recording and nothing on it. I had tried
this before with the same results. I sent the wav file to
my PC and it was silent. Other wav files play fine on my
PC.
Is it for sure that if there is nothing on the wav file,
I would argue that it's 99% for sure that if you can't record the
audio coming in from the USB soundcard's microphone jack, something
is wrong.? I would not worry about Direwolf until you can get it to
record the open squelch noise from your RX radio or some other audio
source.? Please also note that it's important that you add a
decoupling capacitor from the USB soundcard's microphone port to
your radio's audio output.? There is a multi-volt BIAS voltage
coming from the USB device that can harm your radio if it doesn't
have any decoupling circuitry itself.
This is why I wanted to get the periodic device
statistics. Do you have any idea why they do not work?
Could I be typing the command incorrectly? At the wrong
place? Exactly how do you enable the statistics? "direwolf
-a 10"?
Please tell us about your setup:
?? - Radio you're using
? ? ? - Are you using PTT or VOX
?? - Specific USB sound card you're using
???? - How is it connected?? Direct to the Raspberry Pi
(recommended), connected behind a USB hub (not recommended)
?? - Paste in the configuration of your direwolf.conf file
Could it not be working because I don't have the Direwolf
configuration file correct?
Yes, that would cause it.? Please read the documentation and
complete all of the recommended settings before emailing the list
asking why it doesn't work.
--David
KI6ZHD
