Hello Danny,
For changing the internal Kenwood audio audio levels, you're
right.? I'll update my docs.? Thanks!
--David
KI6ZHD
On 02/10/2025 07:17 AM, Danny K5CG via
groups.io wrote:
toggle quoted message
Show quoted text
David,
On your page you wrote
"These settings are specific to the Kenwood D710. If you *aren't using* a D710, you can skip this section."
They are also pertinent to the TM-V71A (same radio).
73
Danny, K5CG
HH 550-0609
SKCC 14257
Hey Joe,
All my sliders are at max which is why I was a bit
worried about this.? My radio is a Kenwood TMD710G.? I
forgot to mention that. I have not checked whether it has
gain controls that could be changed.
Yes.. I have a D710 and this is possible but I think the issue
is more on the sound device side.? In addition to AGC, your
sound device might also have a preamp that might need to be
disabled.? Btw, on the D710, are you using the TNC on one VFO
and running Direwolf on the other VFO?? The D710's built-in
TASCO TNC is ok but Direwolf will definitely out perform it.?
How are you connecting your sound device to your D710?? You
should use the 6pin "DATA"? connector on the back of the main
D710 body.
Btw.. if you're curious on the D710 level controls, I cover a
bit of it here:
??
? I also would prefer not to use Auto Gain
Control.? So now I have muted the AGC and the audio levels
are back down to single digits.? I hope I can continue to
use this radio but I can change if necessary.
When you say "single digits", according to what.. Direwolf's
standard out text?
--David
KI6ZHD
