Re: Options for starting direwolf
|
David, On your page you wrote "These settings are specific to the Kenwood D710. If you *aren't using* a D710, you can skip this section." They are also pertinent to the TM-V71A (same radio). 73 Danny, K5CG HH 550-0609 SKCC 14257 From: "David Ranch via groups.io" <direwolf-groupsio@...> To: "direwolf" <[email protected]> Sent: Sunday, February 9, 2025 11:33:02 PM Subject: Re: [direwolf] Options for starting direwolf Hey Joe, All my sliders are at max which is why I was a bit worried about this.? My radio is a Kenwood TMD710G.? I forgot to mention that. I have not checked whether it has gain controls that could be changed. Yes.. I have a D710 and this is possible but I think the issue is more on the sound device side.? In addition to AGC, your sound device might also have a preamp that might need to be disabled.? Btw, on the D710, are you using the TNC on one VFO and running Direwolf on the other VFO?? The D710's built-in TASCO TNC is ok but Direwolf will definitely out perform it.? How are you connecting your sound device to your D710?? You should use the 6pin "DATA"? connector on the back of the main D710 body. Btw.. if you're curious on the D710 level controls, I cover a bit of it here: ?? ? I also would prefer not to use Auto Gain Control.? So now I have muted the AGC and the audio levels are back down to single digits.? I hope I can continue to use this radio but I can change if necessary. When you say "single digits", according to what.. Direwolf's standard out text? --David KI6ZHD |
Danny K5CG