开云体育

I have been bouncing around looking at various posts here but I can't come up with a clear picture of the status. 1. Is this a viable project to me to use 2. Where are the files and schematics? I

Apparently the pump I ordered from China is theoretically in the country so I might see it this week. I found the leak in the reservoir that was causing pressurized air to mix with the fluid

https://www.thingiverse.com/thing:1696019 Sent: August-30-21 11:18 PM To: [email protected] Subject: Re: [digitalhobbyist] A Drip Coolant System #MISC John D Can you send a STL or Dxf of

John D Can you send a STL or Dxf of the pump and gears you printed. I maybe able to scale up and or down a tad to increase the gear contact. Thanks John L -- John

For completeness, if anyone is using Marks code linked in post #1610 below, it's been up dated tonight to alter the behaviour of the alert. Julian

Septembers 2021 cover photo Burger holders 3D printed. Photo shows Male and Female halves fitted together. The female tenon air gap is 2 mm wide , male tenon is1.5 mm thick, total height 38 mm. Two

The gear version is printed as one item. Theoretically the gears have a tiny bit of clearance. With shrinkage they had more than a tiny bit. I don't think it's supposed to be able to come apart. I

John, did you print the whole pump at one time? Ralph

I'd go along with it requiring some sort of carrier ... nice idea though. 3mm ID tube and the original motor will give you quite a respectable flow.? May need to speed control the motor as you can't

Well that was a disappointment. I used 1.5mm and 40% infill. After 3 hours it came off the build plate and the gears were not locked. But it really meshes too loosely. In the photo you can see

For entertainment I've ordered this from China. I've included the tubing because who knows how hard it might be to source. But having said that I'm also printing this since it doesn't need any

I have to admit, printing the pump never occurred to me.? Some nice designs there.

A quick google search shows up items like this: https://www.thingiverse.com/thing:3346506 which is a remix from https://www.thingiverse.com/thing:642192 which is a remix

Hi Julian , good luck with your set up please keep me informed with more photos and text will be following.

Thanks, Gene. Interesting reading ... could be a future project! All be it for a different duty, I've joined ONAEM and I'm using a couple of the little Chinese pumps (linked below) with 2mm ID

Damm, somewhere in my piles of stuff I have a peristaltic pump. that needs a top 3D printed. But I have not seen it in years. I sorta like the gravity drip method better than a pump. I also have a

Hey Julian, Here's a link to the post I've seen a peristaltic pump being used: http://www.mycncuk.com/threads/8061-Fogless-Mister-Systems?p=68214#post68214 The maker doesn't go into a lot of detail,

I can get a pump in about two weeks through amazon.ca for $58 Cdn. Way too expensive if we're going to use the "Obliterate North American and European Manufacturing" (ONAEM) approach. You can make

Thanks John D The most expensive item is the pump I may build a unit later John L -- John

John D Thanks I may build one the most expensive item is the pump John